Preparation of Work2-1
Outline of Body Repair 2-2 |
Outline of Body Repair 2-2
The contents described in this section are the basic processes of repair procedures needed to cut and replace welded parts. Reshape the light damage to the outer panel with patty after corrections by the washer, welder, hammer and dolly.
The table below shows information for this model.
Accurate inspection of Damaged Parts. (Visual) Measurement Wheelbase (see section 1) Wheel Alignment (see section 1) Body Dimensional Drawings (see section 4) Reshape Shop Manual (see section 1) Body Dimensional Drawings (see section 4) Replacement Mass Production Body Welding Diagram (see section 3) Removal (see section 3) Body Dimensional Drawings (see section 4) Installation (see section 3) Rust Prevention Cross Section of Body and Sealants. (see section 5) Soft Chipping Guard Primer Coating Diagram PVC Coating Diagram Area to be Covered by Antirust Agents Paint Apply the paint. (see section 6) Installation
and InspectionShop Manual
Preparation of Work2-1
Outline of Body Repair 2-2 |
При использовании материалов сайта, ссылка на Клуб Honda CR-V (RUSSIA) обязательна.
2006-2011